DoorKing Keypad & Intercom Repair Nationwide

DoorKing Keypad & Intercom Repair: The Agoura Hills Owner’s Guide

DoorKing keypad and intercom repair in Agoura Hills typically runs $220 to $480 installed, depending on whether we’re replacing the keypad face, the intercom board, or the full entry station. We stock DoorKing-compatible parts on the truck and most keypad swaps are done in a single visit. The way owners usually find us is the same story: the keypad stops responding to a code that worked last week, or the intercom buzzes but no voice comes through, and suddenly nobody can get in without a remote or a call to the house. We fix that.

Call (213) 293-3886

Key Takeaways

• We carry DoorKing keypads, intercom boards, and replacement faceplates for most 1800, 1812, 1830, and MicroPLUS series units.
• Typical installed price in Agoura Hills: $220 to $480, quoted and agreed before any work starts.
• We’re an independent service company, not affiliated with DoorKing, and we service what we install.
• Most keypad and intercom repairs are completed same day in a single visit.

Which DoorKing Models This Applies To

DoorKing keypads and intercoms come in a few distinct families, and the part has to match the series or it will not talk to the control board. The most common units we see on Agoura Hills driveways are the 1812 Classic, the 1812 Access Plus, the 1830 series, and older 1800/1808 pedestal units, plus the MicroPLUS surface-mount keypad. A DoorKing 1812 keypad is not interchangeable with an 1830 entry station, even though both are flush-mount. The ribbon cable pin count and the mounting screw pattern are different. Before ordering, we read the model tag on the inside of the keypad housing or on the control board itself. That tag tells us the exact part number, and it saves a return trip.

On the OEM-versus-aftermarket question, we have learned to be careful with DoorKing. The OEM keypads hold up in direct sun because the faceplate plastic is UV-stabilized for California exposure. Some aftermarket equivalents are not, and they yellow and crack within two or three years on a west-facing Agoura Hills gate. We stock OEM DoorKing parts and a small number of aftermarket replacements we have tested on hundreds of gates. We will tell you the price difference and let you decide. We also stock keypad and intercom parts for LiftMaster, Mighty Mule, and Ghost Controls, but the DoorKing hardware is what pays the bills in this area.

Signs Your DoorKing Keypad & Intercom Repair Is Failing

Most DoorKing keypad and intercom failures announce themselves in stages. Here is what we hear on the phone, and what each one usually means once we open the unit.

• Keypad lights but ignores a working code. The membrane or tactile switches under the keys wear out. On older 1812 units, the carbon pads degrade and no longer make contact with the board. Replacement is the fix.
• Some keys work, others do not. This is almost always corrosion or a cracked trace on the keypad circuit board. Moisture gets in around the faceplate seal after years of Agoura Hills morning fog and a few good rain seasons.
• Intercom buzzes but no audio, or audio only one way. The speaker coil or the microphone element has failed, or the audio transformer on the intercom board is done. We replace the board or the speaker assembly rather than chasing solder joints.
• Gate opens on its own or will not close after keypad use. The keypad relay is sticking, or the wiring between the keypad and the operator has a short. This is an access control problem, not a mechanical one, and it needs a meter and a trained look.
• Keypad is cracked, sun-faded, or full of ants. Agoura Hills ants love the warmth inside a keypad housing, and they short contacts. A cracked faceplate lets rain straight onto the board. Both are common, and both are replaceable.

Replacement Cost & What’s Included

In Agoura Hills, expect to pay these installed ranges, through us anyway:

• Surface-mount keypad replacement (MicroPLUS or similar): $220 to $320 installed.
• Flush-mount keypad or entry station replacement (1812, 1830): $280 to $420 installed.
• Intercom board replacement with programming: $320 to $480 installed.
• Full entry station with keypad, intercom, and camera (where applicable): $450 to $680 installed.

The spread comes down to the specific DoorKing series, whether we reuse the existing wiring or run new, and how much programming the replacement requires. Every quote is firm and in writing before a single bolt is turned. The labor includes removal of the old unit, cleaning the mounting surface, installing and sealing the new part, wiring it to the operator, and programming your codes, the intercom ring, and any relay settings. The work is covered by our 90-Day Done Right Promise, in writing, no argument if something is not right.

DIY or Call Us?

Keypads and intercoms are low-voltage, so the shock risk is minimal compared to a gate motor or a spring. But the real risk is miswiring the unit and taking out the control board, which turns a $280 keypad job into a $600 board replacement. If you want to check something yourself first: confirm power at the keypad, look for an obvious broken wire at the back of the unit, and verify the code in the manual. After that, leave it alone. DoorKing boards are unforgiving if you cross the wrong two wires, and we have replaced enough boards fried by well-meaning weekend attempts to say that plainly. If it rolls or swings, we can sort it out – and we will tell you exactly what we found before we touch a thing. Call (213) 293-3886.

FAQs